Looking for experienced opinions on removing k-member.

I did my 69 barracuda front end about 5 years ago. I replaced everything but the lower control arm bushings, they still looked good. It is not Brain surgery, but very physical difficult work. I used rental tools from Oreilly. I torched the rubber out of the bushings and removed the metal parts with a hammer and chisel. Put the new bushings in the freezer to shrink them. Lots of improvising if you want to do it on the cheap.

If you can do it a few hours at a time, it makes it easier.

If you want to limit your time and effort, make it functional, not perfect. Only replace the hard stuff that is bad. Leave the rest alone.

If I do one again, I will buy a harbor freight press.