A body 4 speed in a truck. Can this be done?

Thanks guys, lots of good input here. The general consensus is that it could work with a little massaging but not alot of hard work. I think the hard part would be the clutch linkage location. I may go hydraulic to clear that up. Also getting a new driveshaft. Which I already knew I was going to have to do. I suppose anything is possible with some fabrication. I honestly didn't think the shifter would move backwards. I thought the shifter would be too far forward. The A body Shifter I have has a very short throw. It might be aftermarket, but I haven't looked at it in a while. I remember a shifter on an A203 3 speed I had was super sloppy compared to this shifter.