12:05 Garage- ’70 Duster build

I had to shorten the SPC adjuster sleeves and studs. I'm using the tall ball joint Denny supplies with his UCA. The spindle is a mustang 2 replacement spindle that uses the C5/C6 corvette hub and brake.
Good to know! That was the only complaint the guy who did my alignment. Even on the alignment rack/lift he had a real hard time getting at the adjusters. I’m getting the upgraded set of uca’s from Denny this weekend and will be seeing if his tip/trick of installing the adjusters straight up and down works on my car