Advice on no start. What I have done.

I cleaned the negative battery ground and checked both cables continuity. I'll need to start looking at other grounds. Any specific ones to check?

I did pull the distributor. It's currently out. I replaced the parts one by one, but I have been learning as I go, so I haven't done it the most efficient way. Condenser was among the first. Starter needed to be replaced anyway as the old (large) one was cranking slowly and not helping matters. Cap and rotor were relatively cheap, etc.

The condenser is new from Napa, but I could try another one.
Used this: https://www.napaonline.com/en/p/ECHAL869