3D printed fuel sender gaskets
This one? I could do that one, because of the way it must be printed the top surface would be flat rather than rounded. If you were looking for originality it wouldn’t look quite right, but it might be close.
For 3D printing, one side must be on the printer bed. So that side will be flat. I’d print these upside down so the part you see would be flat, but I might be able to get the edge rounded.
Will that work?
This one? I could do that one, because of the way it must be printed the top surface would be flat rather than rounded. If you were looking for originality it wouldn’t look quite right, but it might be close.
For 3D printing, one side must be on the printer bed. So that side will be flat. I’d print these upside down so the part you see would be flat, but I might be able to get the edge rounded.
Will that work?
