'69 Barracuda T56 swap, floor, cross member
Unmasked the car and got holes drilled in firewall for clutch master cylinder. Had to clearance inner fender with a hammer to get master cylinder to fit. Also reinforcement plate that goes inside the car needed a bit trimmed off it to clear the contour in the firewall on left side. Did not think I would be able to drill through fire wall with pedals in the way so clutch pedal installed removed several times to get master cylinder limed up. Push rod looks to go straight into master cylinder and alignment seems really good. Pedal goes down and up smoothly. Will be able to proceed with permanent pedal installation next.
Unmasked the car and got holes drilled in firewall for clutch master cylinder. Had to clearance inner fender with a hammer to get master cylinder to fit. Also reinforcement plate that goes inside the car needed a bit trimmed off it to clear the contour in the firewall on left side. Did not think I would be able to drill through fire wall with pedals in the way so clutch pedal installed removed several times to get master cylinder limed up. Push rod looks to go straight into master cylinder and alignment seems really good. Pedal goes down and up smoothly. Will be able to proceed with permanent pedal installation next.
