Help spec'ing out a new small block
The valves fit without issue…this is on my dead mock up block with 4.03. New one is 4.09, so there’ll be just a little more room (030 on the edge ain’t much though). Sorry, best pic I could get at the moment:
Whether or not you think you want to notch for shrouding is up to you, but Valley didn’t on their EM motor and it did pretty well.
The valves fit without issue…this is on my dead mock up block with 4.03. New one is 4.09, so there’ll be just a little more room (030 on the edge ain’t much though). Sorry, best pic I could get at the moment:
Whether or not you think you want to notch for shrouding is up to you, but Valley didn’t on their EM motor and it did pretty well.
