Here's some more pictures. The steering box mount gets completely boxed in, and then you add reinforcement around the LCA pivot tubes. The full Firm Feel kit adds reinforcement to the strut rod mounts too, I skip that because I use adjustable strut rods that use large sandwich plates on that part so it's already reinforced.
Here are some pictures from my car
The LCA pivot reinforcements are on the LCA side.You can see in this picture that the flange on the LCA pivot fits inside the reinforcement.
View attachment 1716194993
This is the side under the steering box. If you look closely you can actually see the corner of the steering box gusset, as well as a lot of seam welding that I did.
View attachment 1716194994
Bottom side of the steering box showing the part the gets filled in
View attachment 1716194995
Gusset template showing where it goes, obviously it gets curved to fit
View attachment 1716194996
Frond side of the steering box mount. This one you have to be careful with, if it extends too far forward the steering box will hit it because the box is at an angle.
View attachment 1716194997
Couple more pictures of a K frame with the reinforcing done on it, this is a 68-72 K from
@Seandavid55
View attachment 1716194998
View attachment 1716194999
