moog offset bushings too big?

junkyardhero said
just checking that you're not actually hammering the bushings in and using either the correct tool, or an improvised tool that operates in the same manner of drawing the bushing into the arm with a cup and jack screw arrangement?

beating a set in would likely bend up an arm pretty good.

freeze the bush, heat the arm a little and it should practically slide right in.

I made a socket/pipe/threaded rod puller, definitely not hammering anything. Definitely a cautious kinda guy. Much appreciated,

ch1ll said
.014 is a pretty big difference for parts pressing together.

That's what I felt too. And that's in addition to the original press fit, which is healthy! When I go to redo this, as I put the original bushing back in, I'll measure the arm.
I'll bet the o.e. is .004, we'll see.

Seems like a lot of work just to get some caster haha