Weber DGV float setting
A few pics to show a "35mm float bottom to top" is impossible. Note that these are all shot upside down so the bottom of float is obviously the top of the pic. The pivot pin is about 20mm off the top. If I were to hammer the metal bracket flat it could possibly level out as the diagram shows but the centerline of the bracket to the float is 13mm so that would leave me 7mm to top, not 18mm. These guys are using either a very thin OEM Weber float (17mm) that I don't have or there math doesn't add up. A 17mm thick float would make all these numbers possible: 18mm off the top and 35mm total from bottom of float to top of carb but not a 27mm float. Let's say they changed the way they measure and are now using the 18mm to bottom of float as the new standard. That's a lot of change! And not everyone is reporting this.
A few pics to show a "35mm float bottom to top" is impossible. Note that these are all shot upside down so the bottom of float is obviously the top of the pic. The pivot pin is about 20mm off the top. If I were to hammer the metal bracket flat it could possibly level out as the diagram shows but the centerline of the bracket to the float is 13mm so that would leave me 7mm to top, not 18mm. These guys are using either a very thin OEM Weber float (17mm) that I don't have or there math doesn't add up. A 17mm thick float would make all these numbers possible: 18mm off the top and 35mm total from bottom of float to top of carb but not a 27mm float. Let's say they changed the way they measure and are now using the 18mm to bottom of float as the new standard. That's a lot of change! And not everyone is reporting this.
