360 Cam suggestions

rumblefish360 said
Excellent pertinent supporting information. The zero deck height and small cc head area are about a 11-1 ratio.

Since YOU can work on them, they can be a good head for you.
I would suggest a call to Howard’s cams and ask for a high lift HFT to work with your combination. I myself would yield at a duration of 236*’s @.050, have it ground on a 108 LSA, get as much lift as possible and that the head flows, if possible.

I stated 236*’s @.050, but a lot of this is in flux because of the love that is used can make a 236* ether very aggressive or Just OK. It’s a general area.

Howard’s has a sweet cam at the 236/236. I had YellowRose spec a cam for me and this is what we used but did on a 105. But mine is a 72 duster, 30 over 340 10.5-1 with full kill ported 2.05 Eddy rpm heads, ported air gap, worked over 750 double pumper, 4 speed, 373 and 27-28 inch tire. We wanted a little flex with gearing, so I could run between 355 and 410’s, but my car is built as a corner carver so the 373, and I have a GV on a transmission that we kept in mind when selecting this one.