360 Cam suggestions

Scody21 said
Howard’s has a sweet cam at the 236/236. I had YellowRose spec a cam for me and this is what we used but did on a 105. But mine is a 72 duster, 30 over 340 10.5-1 with full kill ported 2.05 Eddy rpm heads, ported air gap, worked over 750 double pumper, 4 speed, 373 and 27-28 inch tire. We wanted a little flex with gearing, so I could run between 355 and 410’s, but my car is built as a corner carver so the 373, and I have a GV on a transmission that we kept in mind when selecting this one.

Oh I like that. Nice, very nice set up. I like the 4.10’s a/a 28” tire.
Below is an old NOS Crane cam I picked up from FABO a while back that’s getting set into action. I’d have suggest this, but Crane is gone and the cam can only be copied. This works well in a hot rod street car. IMO, it’s about the max I’d suggest for the OP and his set up. Mostly due to the small tire and 3.73 gearing.

The cam card below is being used with Magnum heads so recalculating the lift should be done. Edit, I did the math, it’s now a .530 lift. Works well with the stock heads and the Hughes trick spring kit. Add in a good valve job and a bowl porting and it’ll be a nice enhancement.