Coil - resistor compatibility question.

Hey group. I have researched the information I'm looking for and haven't had much luck finding and answer.
My scenario is as follows;
I purchased an electronic ignition on (God forbid) Ebay from a seller that calls himself mopar_rick. Seemed to know his set up in a email exchange.
The text that follows describes the distributor.
*An OEM-spec distributor with a street-performance advance curve, complete with a high dielectric, brass-terminal cap and adjustable vacuum advance. Uses all stock OEM tune-up parts. IMPORTANT: real "heavy weight" Mopar/Chrysler design -- no spark scatter. Not the Accel "guts" (downsized GM HEI crap design) that were used in MP distributors from 2000 - 2013 and caused no end of problems*
Happy with the quality of the distributor. It included a new ▪︎must use this one▪︎ resistor block.
Prior to this purchase, I had purchased a Petronix high energy coil with a built in 1.5 ohm resister.
My question is, would the coil be compatible with this ignition set up or would I be essentially doubling up on resistance due to the use of these pieces.
Any response from individuals that have dealt with this first hand would be greatly appreciated.
Thanks another folks.