The horse is dead

I'm going to voice command this. So, however it comes out and I will vent as well if you want...
I bought their one point 621 rockers, and they were pretty good, still are..
I went ahead and bought the stud kit and everything and notice one of my studs was pretty high and uh, they're threaded both ways. So I was tightening down the nut on the rocker shaft, and it tightened before it clamped the shaft down..
I call them and they say run it.... It's fine...???
That's a quarter inch gap underneath the shaft, and i'm just thinking these people are complete morons....
I would absolutely never buy a d*** thing from them ever again...
Absolutely, everything on their site is all hype ...
They don't make their own cams, they don't do a lot of things, they just source stuff out and have a couple things.
Actually, I never heard good things from them...