Best 360 magnum cam specs oregon regrind

junkyard kid said
Was going to get oregon to regrind a Hydraulic roller cam was wanting to see if anyone could maybe give some advice stock internals heads hand ported stainless shorties airgap intake 750 holley spread bore carb

I think everyone, including myself forgot you were going with a " Regrind". That limits what you can get in duration and lift.

For reference, in my old Hughes catalog, back when they mainly did regrinds.

The cam profiles they listed as "Available for regrinds". Duration @ 0.050"

192/204 on 114 lsa
209/214 on 114 lsa
214/218 on 114 lsa
218/228 pn 114 lsa

All are on 114. Which is ground into the stock cam. This is great for EFI, But gives up alot of hp/torque for a Carburated setup vs. A 108 or 110 lsa.

With the biggest the lift is .544" with 1.6 rockers.

Their biggest regrind with ported heads, Rpm Air-Gap and 750 carb, headers you are looking at around 420hp potential.