Finally get to pretend I am one of the cool kids - Holley kit swap

Well, not really sure what is going on, but going to ignore it.

I moved the jacks back to about where the door hinges are and under the frame, took a measurement from the floor to the bottom of the rail at the forward k-frame bolt and the rails were different by 1/2", with the left one being lower than the right. That was the opposite of what I expected.

So I tensioned the torsion bars, put the wheels back on and set them on the cribbing. Got the suspension to sit about the same side to side with the bump stops just touching and measured the wheel openings at the centerline of the wheel and at the frame in the same spot as before. This time the wheel openings were pretty much dead on the same and the frame rails were within 1/8" with the the right one being a touch higher like before.

I'm going to put it to bed and not worry about it. Not sure what the wrinkles are about, maybe the rail got hit right under that point and the rail didn't move much. Or maybe it had some frame work way back when and that was as good as they could get it. Either way, I don't think there is much to do about it.

To be clear, I didn't push pause on the project due to this. Still waiting on the borrowed extension cord and taking care of my wife so I haven't been able to move forward for other reasons. At least the break has given me time to find this, think about it way too much and decide it isn't all that important.