What do i have?
Alright,I'm kinda at a road block and waiting on some more parts.
So I decided to get it running and flush some water around for a few douche drain and refills.
I copied the vacuum lines, all 2 of them as was before, which may or may not be correct.
It hits on all 8, and when the rotor is advanced a bit, it idles beautiful, and I don't need to load the idle screw at all.
When I did the timing gear I went 4* advanced, so I set my gun 4* and turned the rotor until the balancer hits zero, and to keep it idling I need to turn in the idle screw, and it runs quite a bit more poppy. The manifolds are open, so its very easy to hear any exhaust note.
For the idle jets I turned them all the way in, then 1.5x out each, then slowly backed them out until the idle cleaned up.
When I dump the throttle it cuts out/backfires out the carb. If I roll into it kinda quick, it spits and fires like its rich.
Does this scamazon carbinator have fast idle jets to adjust? Doesn't look like it .
Unfortunately I can't really load the engine until I get my pump and hoses plumbed, so maybe i am limited having just sit here in neutral. At the same time I'd rather check and make sure I'm getting a ground zero to build off of.
The fuel I'm using isn't terrible old. Maybe 3 months at most. I'll grab a jug for the next play. The starter needs to come off. For some reason the solenoid throws but won't send power to the starter after its hot. I'm so annoyed.
Alright,I'm kinda at a road block and waiting on some more parts.
So I decided to get it running and flush some water around for a few douche drain and refills.
I copied the vacuum lines, all 2 of them as was before, which may or may not be correct.
It hits on all 8, and when the rotor is advanced a bit, it idles beautiful, and I don't need to load the idle screw at all.
When I did the timing gear I went 4* advanced, so I set my gun 4* and turned the rotor until the balancer hits zero, and to keep it idling I need to turn in the idle screw, and it runs quite a bit more poppy. The manifolds are open, so its very easy to hear any exhaust note.
For the idle jets I turned them all the way in, then 1.5x out each, then slowly backed them out until the idle cleaned up.
When I dump the throttle it cuts out/backfires out the carb. If I roll into it kinda quick, it spits and fires like its rich.
Does this scamazon carbinator have fast idle jets to adjust? Doesn't look like it .
Unfortunately I can't really load the engine until I get my pump and hoses plumbed, so maybe i am limited having just sit here in neutral. At the same time I'd rather check and make sure I'm getting a ground zero to build off of.
The fuel I'm using isn't terrible old. Maybe 3 months at most. I'll grab a jug for the next play. The starter needs to come off. For some reason the solenoid throws but won't send power to the starter after its hot. I'm so annoyed.