Happy Easter, everyone. I don't remember how or where I acquired this pressure plate, but it was in this condition when I got it. It's been collecting dust on the shelf for a while, so I figure it's time to do something with it.
You can see it's been used, and there are a couple areas of surface rust from the clutch disk sitting on it. The overall feel when I run my fingers over it is like 600 or 800 grit, and there aren't any places I can catch a fingernail on.
My question is this: is it acceptable practice to resurface a plate like this, or should I chuck it in the scrap bin? Seems wasteful to throw it away, but if it's junk, it's junk.
Thanks as always!
View attachment 1716395200View attachment 1716395201View attachment 1716395202View attachment 1716395203