Heater instrument panel differences for 67?
There are some photos here.
Radio bezel
The 67 the levers pivot the 68 up they slide
67 (the "Plate" is not in this photo)
68 up
(Red arrow points to a bolt I used to replace the OEM center pivot and retainer.)
67 Dash frame
The red arrow shows the 67 glove box door hinge opening
The 3 red circles are where OEM tabs on the heater bezel go through the dash frame and have clips on the back side ALMOST always they are broken off. Really bad design!
2 Red circles at radio opening are the post holes for the radio.
Blue circles are where the "Plate" screws to
This plate is screwed to the heater bezel AND to the heater control which is screwed to the dash frame
Blue circles screw to the dash frame
Upper red circles screw to the bezel
lower red circles screw to the heater control
red arrows are the alignment tabs on the bezel
red outline is the plate
upper red circles screw the plate to the bezel
Blue circles mount the plate to the dash frame
lower red circles mount the heater control to the plate
bezel alignment posts are just below
This is 68 up dash frame
red circles are the screw holes for the bezel
blue circles are the heater control mounting holes
68 up the "Plate" is part of the control (it's where the lever sliders slide)
red arrows are the radio mounting holes (thumb wheel radio)
Note there is no glove box hinge hole. there is a bit of 68 up hinge visible just below the black on white arrow
Someone just posted a 67 heater control for sale and it has the plate on it.
Red arrow is the plate
Green arrows are the broken plastic posts off the bezel
There are some photos here.
Radio bezel
The 67 the levers pivot the 68 up they slide
67 (the "Plate" is not in this photo)
68 up
(Red arrow points to a bolt I used to replace the OEM center pivot and retainer.)
67 Dash frame
The red arrow shows the 67 glove box door hinge opening
The 3 red circles are where OEM tabs on the heater bezel go through the dash frame and have clips on the back side ALMOST always they are broken off. Really bad design!
2 Red circles at radio opening are the post holes for the radio.
Blue circles are where the "Plate" screws to
This plate is screwed to the heater bezel AND to the heater control which is screwed to the dash frame
Blue circles screw to the dash frame
Upper red circles screw to the bezel
lower red circles screw to the heater control
red arrows are the alignment tabs on the bezel
red outline is the plate
upper red circles screw the plate to the bezel
Blue circles mount the plate to the dash frame
lower red circles mount the heater control to the plate
bezel alignment posts are just below
This is 68 up dash frame
red circles are the screw holes for the bezel
blue circles are the heater control mounting holes
68 up the "Plate" is part of the control (it's where the lever sliders slide)
red arrows are the radio mounting holes (thumb wheel radio)
Note there is no glove box hinge hole. there is a bit of 68 up hinge visible just below the black on white arrow
Someone just posted a 67 heater control for sale and it has the plate on it.
Red arrow is the plate
Green arrows are the broken plastic posts off the bezel