Gap for brazing thin casting? Non-automotive
Small bevel helped.
The pieces were short enough that setting them upo tight there was no noticible opening of the gap. I tried to preheat on a hot plate and then with the torch.
What I found helpful was using the smallest diameter rod 3/32 of which there was just a partial one left. Not sure what the material is as its no longer listed in Eutectic's catalog. I'll have to contact them. Melting point is significantly lower than the 146.
Did not quite flow through all the way.
Small bevel helped.
The pieces were short enough that setting them upo tight there was no noticible opening of the gap. I tried to preheat on a hot plate and then with the torch.
What I found helpful was using the smallest diameter rod 3/32 of which there was just a partial one left. Not sure what the material is as its no longer listed in Eutectic's catalog. I'll have to contact them. Melting point is significantly lower than the 146.
Did not quite flow through all the way.