Rear seat bottom removal tricks

There is a tool for this that can easily be made. It is about a 12 inch narrow bar with a hook 3 inches off the end facing up to push the wire. It goes under the seat on its side . Move it up against the hook and and stand it up to push the round wire on the seat. Push the flat upright handle and the seat wire pops right out of the hook.

They do get stuck pretty good especially if you pick the seat up to hard it bends the wire toward the front . Then you have to push farther back. The more you pick it up the more it gets stuck. Then you definitely will need the tool . A jack will push the whole seat frame. Just like taking it out by hand which usually works for guys with big arms . Its the wire that needs to be pushed . The tool can be used on most all Mopars