Curious About an Additional Weld Line on a Narrowing

The welded on flanges at the end have much less leverage . Also why is the end off center if they straightened the housing before putting the ends on?
They will never admit what they did or why they did it if they screwed up. The main thing is they didn't contact you and tell you that your housing was bent. They are saying its their way or the highway. They should have given you the opportunity to send them another housing. You didn't ask them to repair your housing you asked them to narrow it. But this would have shown the housing was straight to start with.

Looking at your pictures the end is still welded on offset. So didn't they straighten it enough? Or did they slice it so they didn't have to cut the end back off that was welded on wrong? I would never trust them now. we have housings A,B,C and E. And many of them . Not a one bent one in the house. You just so happened to buy the rare bent housing to narrow. Cut me a break.. You Pm'd me and I gave you our number to call. You didn't.

I under stand your frustration and don't want to accept that you got had. Some of these places have reps that could sell ice to an Eskimo.

Like if you would send a block here for a .030 bore and a tool would break boring it. Then I would tell you we had to sleeve it because it was cracked. But it was magnafluxed and pressure tested before any machine work was done. I hope you were wearing boots when the gave you that line of bullshit.

THEY SHOULD HAVE CONTACTED YOU BEFORE ANY WORK WAS DONE IF IT WAS BENT. Now your stuck with your thumbs up you *** and the only proof you have is the end is still off center. I wouldn't accept that weld on my Housing no matter what their excuse is. I am so glad you posted this. they just lost me as a customer. I'll never buy anything Moser again for any customer. They should admit they were wrong. even if it is for not contacting you and refund you money.