70 dart 470 ci drag car build.
Just took lunch and redid something on my intake valves.
When I originally did the valve job I added a back cut ...well let's just say I didn't know any better,
So I chucked the valves into the surfacer and ran a 15° out to a much narrowed and steeper 38°
back cut.
It left a step I needed to remove, bad enough I was considering buying a new set of valves.
Anyways with the "f" it mentality I came up with this semi rough swirl and blended my mess up to the stem and just about made everything the same with a cut off wheel and the valves chucked in the drill press.
Sorta happy about the results.
Just took lunch and redid something on my intake valves.
When I originally did the valve job I added a back cut ...well let's just say I didn't know any better,
So I chucked the valves into the surfacer and ran a 15° out to a much narrowed and steeper 38°
back cut.
It left a step I needed to remove, bad enough I was considering buying a new set of valves.
Anyways with the "f" it mentality I came up with this semi rough swirl and blended my mess up to the stem and just about made everything the same with a cut off wheel and the valves chucked in the drill press.
Sorta happy about the results.