No start with new wiring and battery relocation

matthon said

You said you had power to coil, what about distributor?

I have an AAW harness.

AAW wiring diagram below.

Stock ignition switch has BAT, ACC, SOL, IGN1, IGN2.

BAT 12v from battery.

ACC feed.

SOL to starter solenoid.

Pink IGN wire powers MSD and coil, and since IGN1 and IGN2 on the switch are start and run, I hooked both to the pink wire.

Pink wire goes to coil, wire from coil to distributor.

View attachment 1716454138

Click to expand...

NO THAT IS NOT correct SOL wire from key does not go in series with the neutral switch, and does not go to solenoid

The circuit path from the ignition switch S wire (OEM YELLOW) is direct to the start relay coil, through the coil out on the NSS wire, down to the transmission, and to the center terminal of the NSS. If a stick car, ground the second coil terminal or run it through the clutch switch which then grounds it

The RELAY then activates the solenoid by way of the "big square" terminal on the start relay, no. 12 or 10 from there to the starter solenoid