Door dropping on my 70 Duster

George Jets said
2x4 along lower door rear inner frame > floor jack to bend up inner door frame to raise rear of door.

If you are creative you can carefully use a long pry bar under the 2x4 stabbing it in at the top rocker panel step plate area, and pull up on the pry bar to raise the door.

this by far unequivocally the most terrible, god awful, horrible advice i've seen here in quite some time.

this is straight up 1970's used car sales lot bobo *** hackery. atrocious at every level.

George Jets said
Careful, Careful, protect areas that you don't want to do damage to.

protect the areas you don't want to do any damage to?!??

yeah like the ******* door frame that you're bending?!??

this is bad advice george and you should feel bad for even suggesting it. be better than this.