Adjustable upper control arm opinions.

tcanin00 said
Yes, the eccentrics are all the way in and it has positive camber. I would believe it's an issue with the car itself. I know these were high production/low quality cars with tolerances of Monday through Friday.
I'll have to do the math to figure out how thick of a spacer I need to correct the camber.

I’d figure out why that right side is so far out. +3° to +.5° is more than just bad production tolerances.

@Kern Dog made a point about a right side PST UCA that was jigged incorrectly, might not be coincidence that your right side is also the one that’s off

Demonx2 said
I believe the 1.0's are still available elsewhere, just not from Peter. The bad would be that the ones Peter sold came with the Delrin and zerk fittings. I don't think ones purchased elsewhere have that.

Yeah there are SPC genI’s around still, I think SPC has discontinued them so you’re looking at who still has stock on the shelf.

Believe you’re correct about the bushings and zerks too.

The Gen II’s are very nice, but they are pricey.