A-Body Frame/Body Jig

Oldmanmopar said
I can give you the measurements for the heights of the body legs It is in the shop right now with a car on it. . Ours is a fixed stand for 67-76 A-bodies. The first pics are of adjustable stands where you can change location and height. Ours is heavy duty and can be used to straighten bodies or assembling bodies. The tubular stands are for dismantling and assembling bodies. Note the leveling legs to the floor. If the floor your on is not level these take the flex out of the stand. Even though ours is made from solid 3/4 steel plate and I-beams it still flexes and changes the structure.

View attachment 1716037029

View attachment 1716037030

View attachment 1716037031

View attachment 1716037032

View attachment 1716037033

View attachment 1716037034

View attachment 1716037035

View attachment 1716037036

View attachment 1716037037

View attachment 1716037038

I found this post again. I used the info to install a front clip as you showed. These 8 dowel points you use would be common to all 67 - 76 A-body chassis dimensions I presume? You mentioned you could share the lengths (Difference in height) of each point but I did not see that. I would like to know these so I can construct a similar structure? I have a rail that I suspect is almost identical to your Valiant! I have looked over the frame charts but can not figure out the vertical dimensions.