Screws for rubber shift boot on '65 Barracuda 4 speed

Firstblood said
Sorry man, I got your thread confused with another asking if boot was installed over or under carpet, and the screws.
My 6 screws look to be factory #8x3/4" with captive washer.
I have remnants of an original boot with smaller holes than the repop boot.
That's why I added small ss fender washers.

Firstblood, You didn't get confused, thats my fault, I edited the post to remove the question because no one had responded and I started thinking the boot went under the carpet because the boot would be exposed if the carpet went under it. Well...now that I have screws that fit the application, I'm starting to realize that if the boot goes over the carpet, the carpet trimming would be easier, and it looks as though the rubber would only be exposed only around the edge of the bezel. Since I don't have the carpet installed yet, I'm just going to wait and see how it goes. The screws I found are from Home Depot, they are #10 x 3/4 black with built in washer and fit well. The lower picture shows the bezel over the rubber, which I believe is what you did, I appreciate your input.