What unobtainium parts are needs? starter list

broughj said
I thought I had a picture of the damaged vents before I removed them, but apparently, I don't. The pictures from under the package tray shows the long tab on the bottom of the part aligned with a slot in the metal package tray. I think this would fix the correct orientation. That tab on your part appears to be shorter than on the original part, so it might need to be lengthened some to use it as an alignment pin. Your part that you printed looks great. Thank-you for taking on my project. Not sure how many folks might need a set of these, but I for one do.

Regards,

John View attachment 1716497519 View attachment 1716497520

The tab on my printed part is same length as the stock ones I have, the hole in the sheet metal is large enough that it does not fix the location of the vent. I would assume that the factory package tray has slots to locate the vent. If the long tab is oriented as you show then the vents point the direction I assumed they would (see picture below). Are you the same person on Facebook that messaged me and wanted them printed in blue? I should have everything I need to start printing these in ASA by next weekend.