67-69 Barracuda Notchback “Rear Air” Defog Vent
Learning cycles.
Process optimization.
I do this at work for an entirely different process, but the methodology is the same.
So, calibrate flows, optimize the angle you print, strategically place supports, and tweak the bed and nozzle temperature.
Bambu H2D
Overture ASA.
Using 0.4mm nozzle and built in flow calibration.
Slowed speeds down…
Angling the face 25 degrees from vertical, and 40 from the horizontal. Default supports with extra touch points on backside of the fins.
95C bed, 60C chamber 250C nozzle.
Definitely a learning experience.
Much better results! The "visible" lines in the photos are more subtle than the images suggest.
Learning cycles.
Process optimization.
I do this at work for an entirely different process, but the methodology is the same.
So, calibrate flows, optimize the angle you print, strategically place supports, and tweak the bed and nozzle temperature.
Bambu H2D
Overture ASA.
Using 0.4mm nozzle and built in flow calibration.
Slowed speeds down…
Angling the face 25 degrees from vertical, and 40 from the horizontal. Default supports with extra touch points on backside of the fins.
95C bed, 60C chamber 250C nozzle.
Definitely a learning experience.
Much better results! The "visible" lines in the photos are more subtle than the images suggest.