Pulling engine & tranny

I'll convince you not to try pulling both together if I can. The tail end of the trans is gonna hit the ground unless the car is way up in the air. This means the engine hoist has to go much higher too. Try my way...
Lift the car and prepare everything under there for engine removal. Next throw a small piece of chain around the torsion bars and draw its end together with a piece of all thread,flat washers and nuts, until it is snug against the bottom of the trans.
Let the car down on wheels and remove the engine. You'll notice the car goes nearly half way back up to where it was just due to weight removal.
Short finish here... the trans comes out and goes back in and back on the support chain perfectly positioned for engine reinstall.