qtr install?

yeah I had to make one from scratch, but at least one side was good enough to mimic the other side. The metal is pretty thin there to begin with but I just made a little piece and tack/grind repeat...
but once you bend the quarter to match and weld it all up it does end up being fairly stiff.
One of the problems I had was while removing the old spot welds and qrtr while trying to keep that thin piece in its original shape. I'm not so sure I got mine back to original dimensions but it sure beats the previous patches that left the quarter behind the wheel about 2 inches below the bottom of the bumper... eww