Carb selection help, please ?

Thanks for the suggestions Rob, I hope to get some time to tinker with it some more before the roads get too crappy ... 2" of slushy snow today !! I did do a vacuum test a couple weeks ago but can't remember the #'s, only that it was a little low ...

The plugs, wires, rotor, cap and electronic box are all new .. The cam would have been dialed in when I had it re-built, right ? The timing is a pain in the butt.. The distributor is in the rear, and the only way she seems to wanna run is by turning it to the left (standing on the drivers side) until the vacuum advance hose just touches and slightly bends on the intake manifold...

It's a little frustrating, but it's also cool to tinker with this car again after leaving it sit for the most part, for the past 25 years ... I'm planning on pulling the motor and trans out this Winter and will at least have the heads re-done, and hopefully do a little body work and re-paint it .. It's a fun project and can't wait to get it up to the track in Lebanon next year ...

Kenny