64 Dart 5.7 hemi update thread.
Well i filled in some more small holes today, im sure ill have to go back over a few other little spots, but im almost done with the welding part of the upper rad support. in some of the pics youll see where ill need to trim the opening alittle so that the 97 radiator will fit up against the support. I still gotta figure out what im gonna do about the lower support. I might be able to cut and bend the 66 lower support to get the drop i need. I bought a 97 upper rad support off a grand cherokee to see if i can incorperate it into holding the top of the radiator and hide the radiators bare topless look.
One of the pics is of a dip in the firewall. I was wondering if i could cut that out and just make it flat or did the factory put it in there for strength like the dips in the floor pans? I was wondering because the 67 heater and a/c unit i bought doesnt have the indention to fit this little dip inside of it, making it flat may fix that problem. Maybe i could modify the heater unit to accomidate the dip?
Well its progress. Still got a loooooooooooooooooooooong way to go, but getting the radiator support in and the fitting in the 97 radiator is one of my big boxs to check off, so when its done i can get the pencil out.
Well i filled in some more small holes today, im sure ill have to go back over a few other little spots, but im almost done with the welding part of the upper rad support. in some of the pics youll see where ill need to trim the opening alittle so that the 97 radiator will fit up against the support. I still gotta figure out what im gonna do about the lower support. I might be able to cut and bend the 66 lower support to get the drop i need. I bought a 97 upper rad support off a grand cherokee to see if i can incorperate it into holding the top of the radiator and hide the radiators bare topless look.
One of the pics is of a dip in the firewall. I was wondering if i could cut that out and just make it flat or did the factory put it in there for strength like the dips in the floor pans? I was wondering because the 67 heater and a/c unit i bought doesnt have the indention to fit this little dip inside of it, making it flat may fix that problem. Maybe i could modify the heater unit to accomidate the dip?
Well its progress. Still got a loooooooooooooooooooooong way to go, but getting the radiator support in and the fitting in the 97 radiator is one of my big boxs to check off, so when its done i can get the pencil out.
