what cam for 340 bored 0.30 over?

I have the same basic set up :

340 .030 oversized with TRW forged replacement pistons (flat top 10.5:1 compression)

Steel crank
stock rods with new bolts , reworked, new bushings, etc
stock "X" heads

Mopar Performance .509 lift hydraulic "purple shaft" cam and lifters
Cloyes double roller timing set

Edelbrock TM5 single plane intake (what I had laying around!)
Holley Double Pumper carb
MP electronic ignition


I use it as a race car, but it would work fine as a street/strip package. Just might burn a lot of fuel. Car runs 12.86 @ 105 mph when it is cool outside and low to mid 13's when it is hot and sticky.

If you do more street driving and not much racing you might want something with less duraction and lift to make car more street friendly.

Bob