1.6 ratio rockers. Do they actually hurt the geometry??

Thanks for the input Moper.

The main reason I brought this up is
A: to verify that what I was seeing was true, and
B: because I found a good deal on a set of 1.6 rockers.

Now that I'm finally figuring this stuff out I order my cams how they should be in the first place. I also don't like going through the hassles of trying to make something fit the application when it's not correct. I would just like to stay with 1.5 rockers but the deal I found is a good one so it got me thinking.

About my heads. Actually I didn't cheap out at all when doing them. The problem was back when I had them done I didn't know of any performance shop within 100 miles of me so I took them to the only reputable shop around. Unfortunately even though I had every intention of having them done correctly apparently the machinist wasn't as good as everybody said he was cause what I got back wasn't a near perfect job to say the least. That's what caused the problems I had posted in a thread a few months back when I was trying to figure out what was wrong. I'm sure you also read it in my post about flow numbers.

I have since found not 1 but 2 good performance shops so in the future I know where to go so things get done right the first time.

Everybody have a good rest of the week and thanks for all the input.