Need help with UCA bushings

Just wanted to follow up on this 'cause I was starting to get confused. :scratch:

Talked to Moog tech line on the K7103 offset UCA bushings. The reason the washers are not pre-installed on these like they are on the stock Moog bushings is because the washers will interfere with pressing the bushings into the control arms. That's why washers need to be pressed in after bushings are installed in the arms.

Once washers are installed into the bushings, there should be no slop. You should be able to use existing cam bolts and make your alignment adjustments.

Moog is typically a well designed front end part and all I'll use if available.

Hope this helps. Good Luck