Back on the Duster...aka what i did on my summer vacation

Ahhh....the good...finally got the flex plate,transmission,converter and starter in....hooked up the cooler lines and shift cable....

Flex plate and converter





So...after all that is in,I went to slide the driveshaft in so I can mess around with pinion angle and this is what happens......Shaft will only go in so far then stops...it should slide all the way in.



So,I removed the tail shaft housing and it's back to the tranny shop to have them see whats up with the rear bushing,as I have no reamer or way to hone it out. Somedays I feel like going wide open into a bridge abutment...today was almost one of those days:D