duster 383 k frame ?

I've used sb k members & fab'd some brackets.
What I did was cut about 2 inch or so off the front of the driver side mount
down the middle [only leaving 1' of the removed portion of the tower] and then weld in a plate to box it in also capping off that 1' portion left, so the piece you weld in is like an L cap. You don't have to remove the factory gusset ,unless going to power steering lol. I have a pic if needed to grasp this route.
I choose this over crooked hanging off the edge of the tower shoemker mounts and I'm much happier.