Temp and Gas gauge repair

Wow, looks very similar.;) That's my article.

My only concerns with how that looks are:
First, make sure you're never going to contact the hot leads with the circuit board. I put electrical tape under the wires to make sure they didn't hit the bottom. And make sure the IC pins aren't going to contact each other either.

Second, is that clip really well connected to the board/post? Mine had broken on its own, so I have no clue as to how secure it was when it was intact. Should work fine if it's solidly on there.

Third, have you isolated the internal voltage regulator? I mean the one inside the fuel gauge. If it's still in action, your probably going to get some funky results.

Let me know if you have any other questions.