Help me build my SB Stroker

Thanks for all the good info in this thread. I really appreciate everyones time and information!

I am going to look at using a dish piston at zero deck to get good quench and a static CR of around 10.5 to 1. I will also try to find the lightest pistion I can. I will take my block to the machine shop and have them rough bore the one rusty hole to see if it will clean at 4.030, 4.060 or 4.070 all of which I can get a standard piston for...... It may not be as bad as I think.....

Once I get my bottom end going, I will look into cams. Moper has "sucked" me in to his way of thinking..... LOL. I would also like to get a reputable shop that is use to porting heads to flow a couple cyliners on each of the heads I have so I know where I am at on flows. I would think this would also be helpful in picking the cam. I will give BJR a call soon. I looked and I can't find my pictures I took of the heads anywhere...... I will try to shoot some soon and post here.

What about intakes? With the info on this thread sould I be looking at using a single plane instead of an Air Gap RPM?