440cid LA

Here's the deal. I have a siamese bore R3 block, 59 degree 4 bolt mains. It can be bored up to 4.22. While I'm not going to go that far I figure I can get an off the shelf piston blank for a .060 over 400 Chevy small block and a good race ring package. That would put the bore at 4.185. With a 4 inch stroke I'm looking at 440 cubic inches of LA rat stomping power :D.

By upgrading my W5's to a 2.08 intake I figure I should be able to make close to 700 HP with it. What I'm not sure about is the cast stroker crank. I may want to go steel on this. I'm collecting some parts now (already got a set of Eagle H beam 3D rods and the block) but I need to back half the car first so I can get a good size tire under it and a four link.