Stupid Distributor Questions

The AVS rods/jets are discontinued and no longer available.

If you want to jet that carb up Edelbrock jets will work in the secondaries out of the box without modification. You can run Edelbrock jets/rods in the primaries if you run the flat AFB/Edelbrock rod caps or fill your domed rod caps so they are flat on the inside. The Edelbrock jets/rods are like the old AFB where as they are two step. The AVS rods are three step. You can NOT mix and match Edelbrock rods/jets with AVS rods/jets on the primary side. If you run Edelbrock jets you must run Edelbrock rods together with them.

The bushing the above poster was referring to is the distributor drive gear bushing that is pressed into the block. It sits under the distributor drive gear. That is normally only done during an engine rebuild.

Did you change the fuel pick up filter in the gas tank?