conversion kit for /6

-
varlo

varlo

Joe- Long Island, Oakdale
Joined
Dec 3, 2008
Messages
1,299
Reaction score
10
Location
Long Island
I am picking up a 360 for my 75 scamp on saturday and only have the /6 kframe so if i cannot find the proper k frame for the right price i will buy the conversion kit. The problem i have is that the 360 is out of a truck. So do i need a 360 oil pan out of a car for this conversion to work. Any help on this would be nice.

thanks in advance,
Joe
 
You need the conversion mounts & a center sump oil pan & pickup tube. Basically a car pan. The pan has to be for the type 360 you have. I think Magnum 360 engines use a different pan than non-Magnum.
 
thanks guy's so i just looked up some oil pans money is kind of tight right now due to the fact that im a full time college student and can only work a few hours a week. And also the fact that i just purchased new floor pans quarter panels and trunk pan for my 75 scamp along with a 360 4 speed pedal assembly and a 4 speed overdrive transmission. So i have spent a lot none the less i want to do this project right so if you guys could just make sure this will work. I believe so but just want to double check. and also anybody with feedback on the /6 k frame adapters as far as holding up or any problems with them. thanks again guys for the help but as much help as i can get will really do me some good. heres the link to the pan http://cgi.ebay.com/ebaymotors/MOPA...127530722QQrdZ1QQsspagenameZWDVW#ht_515wt_947
 
I have a 73 /6 Dart and a 72 V-8 Demon with a 75 K-frame in it. I can't tell the difference between the two k-frames. Seems to me all you'll need to drop the engine in is a pair of front motor mounts with the isolators in them for the 73 340 and 74 & later 360. The passenger side mount is the same as the 318, the driver's side is different. You'll also need 2 grade 8 bolts long enough to go through the K-frame mounts and a couple of stout washers at each end with appropriate nuts.
 
quick question..... for those of you that have used the conversion mounts. Do you have any complaints? easy install? any problems like cracking or breaking? just trying to get some feedback and good reviews before i purchase.

Thanks,
Joe
 
ok i picked up my motor tranny quarter panels floor pans trunk pans and trunk extentions! There is one problem. According to the tag my 360 out of a truck is out of an 82-88 i cannot remember exactly but if it is crucial for this question i will go out in the garage and look. but heres the link to the pan http://ads.shoppingads.com/pagead/l...127530722QQrdZ1QQsspagenameZWDVW#ht_515wt_947

Thanks for any help you guys can give me i appreciate it.
 
That pan looks like it will work for ya.If the picture is right just use pan gasket for a LA 360 (pre Magnum) good luck
 
You must log in or register to reply here.
-

Back
Top