Little $250 69 Valiant

Well, after several attempts at getting the photos resized for the site I finally have them situated (I think).
So there is a pic of the hood after I used my new d/a to strip it. Then I moved on to the R/R quarter and made things move a little quicker by using 80 grit on a grinder and being very careful not to remove steel or get it too hot while doing it.
Now I knew there was damage in the rear, but I was surprised what I found in two different ways.
1. I figured the bondo would have covered more of an area.
2. I realized it was deeper than I thought.
Either way I spent a few hours banging on it and brought it much closer to where it should be.
Ill be honest I was hoping to have left that bondo alone because Im not to confident in my bondo skills, but when I seen the rust through the splits I knew it had to go.
So here is my latest endevour.