Clutches & Pressure plates?

When I first put the 360 in my Barracuda i purchased an OEM replacement from ZOOM. It worked OK but I couldn't adjust the pedal correctly. If i adjusted for the proper free play the fingers would contact the disk when pedal was near the floor. One of the finger supports broke after about 18k miles so I needed at least a new pressure plate.

I wound up purchasing a RAM street/strip clutch (rated for 500 HP). This clutch works much much better than the ZOOM. More linear, progressive and smoother (there is a wave spring between the two layers of friction material the ZOOM did not have). It is slightly stiffer to the leg but not really an issue, just something I noticed between the two brands (I drive the car daily in traffic). Also, this clutch can be adjusted without the fingers touching the disk. The hub of the disk is about 1/4" higher than the friction surface where the ZOOM was about 1/2" higher, that is the reason the ZOOM couldn't be adjusted.

If you are looking for a reasonably priced street/strip clutch for a sb less than 500HP I would highly recommend the RAM Street Strip clutch from Summit.