BBD > TQ mounting/linkage issues?
2bbl linkage to a 4bbl carb, in this case, a AVS, just make sure the rear area where the kick down rod comes up from the tranny is not leaning foward and that the shift point is very close to where it is now.
The bolt, washer and NYLON LOCK NUT were used here, but you can also use a regular nut and lock washer. Move this foward enuff so the carbs arm contacts it and dosen't move it early on in the throttle operation.
The cotter, er saftey looking clip is there for pictures only. (Last picture)
2bbl linkage to a 4bbl carb, in this case, a AVS, just make sure the rear area where the kick down rod comes up from the tranny is not leaning foward and that the shift point is very close to where it is now.
The bolt, washer and NYLON LOCK NUT were used here, but you can also use a regular nut and lock washer. Move this foward enuff so the carbs arm contacts it and dosen't move it early on in the throttle operation.
The cotter, er saftey looking clip is there for pictures only. (Last picture)