ahhh. finially seats... :)

so i pulled the rug back. cut slots out of the insulation i had put down when i did the carper in the mid 90's.




there are four little dimples in the floor where a stock bucket would bolt. i marked the dimples and lined the seats up over them.

the drivers bracked landed dead on all four dimples so thats where it was drilled.

the passengers side bracket lined up on the dimples closer to the door. the other two holes were about an inch closer to the floor hump then stock seats would be. no big deal though.


hard to see but i marked the dimples.




here is how far the passenger side holes were.