Advice needed! TransCooler W/AN Fittings... NEW TO ME!

I am working out all the fittings I need to install a new Transmission cooler in my car.

I have a 440/727 in a '74 A-body. I am going to mount the transmission cooler in front of the radiator, in the lower drivers side corner.

My Plan is to use this transmission cooler:

B&M 70274 Fluid Cooler, Engine, Transmission, Plate-Type, Aluminum, Black, 11 in. x 11 in. x 1 1/2 in.

With this black -6AN hose from Earls:

EAR-352006ERL Hose, Pro-Lite 350, Braided Nylon, -6 AN, 20 ft. Length,

I am going to use 4 of these 1/8"NPT to -6AN adapters, 2 in the case of the transmission. The other 2 in the factory transmission cooler in the radiator.

EAR-AT981662ERL Fitting, Straight, -6 AN Male to 1/8 in. NPT Male, Aluminum, Black Hard Anodized, Ano-Tuff,

Then I am going to go to the auxilary transmission cooler VIA the -6 Hose ends and these -6AN to 1/2" Adpaters.

EAR-AT809106ERL Fitting, Hose End, Ano-Tuff Swivel-Seal, 90 Degree, -6 AN Hose to Female -6 AN, Aluminum, Black,

EAR-AT981668ERL Fitting, Straight, -6 AN Male to 1/2 in. NPT Male, Aluminum, Black Hard Anodized, Ano-Tuff,


Now, I have never worked with AN fittins or hose but, have been reading about how to work with them.

Seems easy enough... What do you think of the plan?