Startup Procedire ?'s

Ok can someone give me a step by step rundown on startup/break in procedure? It's been a very long time since I started a new motor for the first time and dont want to forget anything!
Motor:
.030 over 440, 11.5-1 compression, Eddy heads, MSD 6AL, MP distributor, Comp Extreme Energy cam .509 intake, .510 exhaust, Schumacher headers, RPM intake, Mighty Demon carb

I have oil in the motor (Rotella 30wt and a bottle of Comp Cams Break in Additive), cooling system is full, t-stat pulled out, all wires hooked up etc, I plan to prime the oil system before startup, and I know to run it at 2-3,000 rpm for 20 mins, fuel tank will have 10 gallons of CAM2 in it...

#1 What do I want the timing set at once it fires?

#2 What if anything else to watch for/or do?

Thanks
Ryan